DIY Handlebar Muffs
Handlebar muffs - try 5 liter plastic containers cut to fit instead of soft 'proper' handlebar muffs. If your'e clever you can even make little struts onto the bar ends to hold them out so they don't collapse onto the brake/clutch/kill switch at higher speeds. They're much safer than thick bulky gloves that stop you working the controls. And they cost nothing.
If you don't like them try motocross/enduro handlebar guards. They look cool and still give a little shelter for your digits.
If you don't like them try motocross/enduro handlebar guards. They look cool and still give a little shelter for your digits.
Bob - Yorkshire
Important Disclaimer
Advice given in this section may or may not be accurate, safe or wise. Always use common sense and when in doubt assume that any advice given herein is incorrect and liable to end in terminal engine or part failure and possible injury or death. www.ratbike.org and its contributors can accept no responsibility for anything, anywhere, regardless of cause.
