Broken Battery Terminal?
Snapped the terminal off your battery? Then simply solder a wire onto the stump. I found it soldered easier than expected as the lead terminal has a low melting point. Then make a loop with the other end of the wire and cover in solder so you can bolt it to the existing battery cable. But be careful to use wire thick enough or you will be starting fires when you crank the engine. I found that 3 lengths of 36 amp wire to be OK for my CB550 rat choppa.
Mouse - UK
Important Disclaimer
Advice given in this section may or may not be accurate, safe or wise. Always use common sense and when in doubt assume that any advice given herein is incorrect and liable to end in terminal engine or part failure and possible injury or death. www.ratbike.org and its contributors can accept no responsibility for anything, anywhere, regardless of cause.
