Insulating a Split Ignition Coil
If your ignition coil is split and leaking electricity insulate it with kit and tape. To keep the water away from the tape I put an empty red bull can (without the top) around the complete coil with tape and kit. This way it looks strange and it works great! I didnt have to buy a new coil and that's the most important part of the story. So when the second coil started to give problems I did the same to that one as well but I didn't have a red bull can so I used a WD40 can instead. Looks even better!
Rainier - Holland
Important Disclaimer
Advice given in this section may or may not be accurate, safe or wise. Always use common sense and when in doubt assume that any advice given herein is incorrect and liable to end in terminal engine or part failure and possible injury or death. www.ratbike.org and its contributors can accept no responsibility for anything, anywhere, regardless of cause.
