clearcoat over bare metal
Strip your metal parts bare,
then sand/polish to whatever degree of shine or satin you find appealing. Then clear-coat right over the bare metal with something that does NOT resist petrol. And don't wipe the parts down with alcohol before spraying - the odd thumbprint will look cool in a few weeks. As the clearcoat chips and gets eaten by petrol splash,
you'll be treated to multiple generations of rusty spots,
looking like your ride has the pox after 6 months,
and looking abandoned after 12. You'll be amazed how rusty a tank can get before it starts to leak...
Eric - USA
Important Disclaimer
Advice given in this section may or may not be accurate, safe or wise. Always use common sense and when in doubt assume that any advice given herein is incorrect and liable to end in terminal engine or part failure and possible injury or death. www.ratbike.org and its contributors can accept no responsibility for anything, anywhere, regardless of cause.
Advice given in this section may or may not be accurate, safe or wise. Always use common sense and when in doubt assume that any advice given herein is incorrect and liable to end in terminal engine or part failure and possible injury or death. www.ratbike.org and its contributors can accept no responsibility for anything, anywhere, regardless of cause.