Automatic Chain Oiler
Automatic chain oiler, cheap and easy. At first I had a mustard bottle inserted through a hole drilled into the chain guard.
Now, I drilled a hole in a oil plug on the right side of the engine on my 78 CB750F. I tapped the hole for 1/8 in pipe thread and screwed in a valve so I can adjust the flow. After attaching plastic tubing to the valve, I routed the tubing to the bottom of the rear sprocket. I used a hose clamp to secure a peice of steel rod to the swingarm and bent it in position just over the chain next to the sproket and secured the tubing to the rod with zip strip wire ties.
Now I can roll on with out ever worrying about the chain. Just have to check the oil a little more often. see pictures
Mark
Important Disclaimer
Advice given in this section may or may not be accurate, safe or wise. Always use common sense and when in doubt assume that any advice given herein is incorrect and liable to end in terminal engine or part failure and possible injury or death. www.ratbike.org and its contributors can accept no responsibility for anything, anywhere, regardless of cause.
